READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever you are removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break

Begin by placing the Dash Trim Tool (Part #SIT-104) beneath the lower left corner of the dash bezel. Pry towards you to release the lower left clip. Continue clockwise around the bezel to release a total of 6 clips (There are two near the bottom, two in the middle, and two near the top). Pull bezel away from the dash just far enough to gain access to the Phillips screw to the right of the climate control cavity as shown in middle picture.

Remove the screw and set aside in safe place. Place the Custom Bezel Mount over the screw hole and replace factory screw and tighten. Make sure to hold the Custom Bezel Mount flush to the edge of the dash so that it is properly aligned. Carefully reinstall the dash in reverse order completely securing all clips and the trim bezel. Install any Bracketron phone holder or Amps compatible device to your Custom Bezel Mount.

source

Related Tags: amps, bezel, climate control, compatible device, control cavity, Dodge, dodge stratus, drivers seat, phillips screw, safe place, screw hole, seat position, unnecessary force