Installation instructions for the Eclipse, Stratus Coupe, and Sebring Coupe. (See reverse side for Mitsubishi Outlander, Lancer/Sportback, and Mitsubishi Montero instructions)
Locate and remove two (2) screws from the bottom of the trim bezel. With your hands or Dash Trim Tool (#SIT-104), release the bezel from all clips. There are two (2) clips on the bottom and two (2) on the top of this bezel. Remove bezel and set aside carefully.
Locate and remove two screws that secure the right side of the climate control. Set screws aside in safe place. Place smaller part “A” over holes as shown in middle picture. Replace factory screws and tighten.
Reinstall the dash bezel until all clips are secure. Replace two screws on the bottom of this bezel. Once bezel is scure, connect the larger part “B” to smaller part “A”. For Dodge Stratus ad Chrysler Sebring, use hole pattern (1). For Mitsubishi Eclipse, use hole pattern (2). Use the two (2) provided cap nuts and tighten part “B” to part “A” with a 5/16” open end wrench.
Install any Bracketron phone holder or Amps compatible device to your Custom Bezel Mount. Your installation is complete.

Source

Related Tags: , , , , , , , , , , , , , , , , , , ,