Vehicle preparation:
1. Remove the negative battery cable before installing the cruise control components for safety precautions.
2. Jeep wrangler applications: remove airbag by using (3) trim tool to release metal clips as shown in figure 2. Caution: ensure that battery has been 90 seconds disconnected for more than prior to removal of airbag; failure to heed this warning may result in airbag discharge and may cause serious injury or death.
3. Dodge caliber, jeep compass/patriot applications: remove airbag by extracting the (2) 10mm screws as illustrated in figure 2a.
4. Press in sides of both connectors to remove airbag figure 3. As illustrated in caution: be airbag sure to store face up as figure 3a illustrated in to reduce injury in event of accidental discharge of airbag.
5. Jeep wrangler applications: remove 13mm center bolt to take off steering wheel, then skip to step 2
6. Dodge caliber, jeep compass/patriot applications: remove (3) torx 25 screws to release center bracket inside steering wheel. Figure 4
7. Remove ecm connector furthest away from fire- wall. Figure 5.
8. Press in tab to remove top cover of connector to access pin locations. Figure 6. Then figure 7. Slot clip as shown in at this point, look for wires in pin locations 27. If wires are present, then the installation and of the ecm harness is not required. Reassemble the connector and skip to the control switch instal- lation on page 5.

Source

Related Tags: , , , , , , , , , , , , , , , , , , ,