Engine, removing and installing Note: All cable ties opened or cut during engine removal must be reinstalled at the same locations. Remove engine without transmission toward the front. Drained coolant must be stored in a clean container for disposal or reuse. Always replace seals and gaskets. Do not open coolant circulation system.
Removing
First determine whether a coded radio is installed. If so, determine the correct coding. Switch ignition off and disconnect battery Ground (GND) strap. Remove bolts (arrows) and remove engine covers -A- and -B-. Remove cover above air filter. Remove plenum cover. Remove sound-proofing material (arrows). Remove bracket for sound-proofing at unit support. Drain engine coolant => page 19-19 Remove front bumper: => Repair Manual, Body Exterior, Repair Group 63 Remove lock carrier: => Repair Manual, Body Exterior, Repair Group 50 Remove viscous fan counter-hold using 3212 spanner wrench. Note: The viscous fan has a left-handed thread. Mark direction of rotation of ribbed belt To loosen ribbed belt, turn clockwise using 17 mm box wrench until two holes are aligned (arrow). Counter-hold in position using 3204 drift. Note: Mark direction of rotation of ribbed belt. Reversing the direction in which it runs can ruin it. Remove ribbed belt.

Source

Related Tags: air filter, arrow, arrows, audi b5, biturbo, bolts, box wrench, carrier repair, circulation system, coolant, drift, engine coolant, front bumper, gaskets, liter, plenum, repair group, ribbed belt, seals, sound proofing material