Please follow these installation instructions carefully. The K&N Drycharger included in this kit must be installed on the K&N air filter when used with a K&N Typhoon Cold Air Intake System. The K&N Typhoon Intake System is a performance product that can be used safely during mild weather conditions. During hard and inclement weather conditions, you must convert your Cold Air Intake System into a short ram configuration, or return your vehicle to the stock OEM airbox and intake tract configuration. Failure to follow these instructions can void your warranty.

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Undo the two hose clips and remove the intake tube from the vehicle.
3. Following manufacturer’s instructions, carefully remove the battery from the vehicle.
4. Remove the three bolts securing the battery tray to the vehicle.
5. Carefully remove the battery tray from the vehicle.
6. Remove the two bolts securing the air box and carefully remove the air box from the vehicle.
7. Fit the vibration mount to the stock air box mounting point.
8. Fit the nut and washer to the top of the vibration mount.
9. Fit the silicone stepped hose to the throttle body and tighten the #350 barrel clamp supplied.
10. Install the longer two bend intake tube to the silicone stepped hose using a #300 barrel clamp supplied.
11. Install the bolt and washer through the bracket into the threaded hole in the valve cover and tighten the bolt, then tighten the hose clip on the stepped silicone hose.
12. Install the hump hose approximately 2.5cm /1” onto the intake tube and tighten the hose clip.
13. Install the second intake tube approximately 2.5cm / 1” into the hump hose.
14. Fix the bracket onto the vibration mount using the nut and washer supplied. Then tighten the hose clip.
15. Following manufacturer’s instructions, chalk the vehicle then carefully raise the front of the vehicle and support with jackstands then remove the under tray.
NOTE: If the under tray is not present on your car, K&N strongly suggests that you contact your car dealer to purchase one.
16. Fit the pre-charger around the filter.
NOTE: The Drycharger’s water repellant properties will last up to two years. See the parts list to re-order Drycharger if necessary.
17. Fit the filter onto the end of the second intake tube using the hose clip supplied.

source

Related Tags: 8l, air intake system, airbox, battery tray, cold air intake, cold air intake system, fiat punto hgt, hose clip, hose clips, inclement weather conditions, intake tube, mild weather conditions, negative battery cable, performance product, punto abarth, ram configuration, silicone hose, stock air, throttle body, typhoon intake