The AEM Short Ram Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced short pipe air intake system on the market. Each system is specifically engineered for its particular application. All AEM Short Ram Air Intake Systems deliver maximum performance gains through lightweight, all-aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range.

Read and understand these instructions BEFORE attempting to install this product.
1) Getting Started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Disconnect negative battery terminal.
d) If engine has run within the past two hours let it cool down.
2) Removing the stock air inlet system
a) Disconnect the breather hose from the stock inlet piping and set aside as it will be used in the installation of the AEM intake.
b) Remove the two hose clamps securing the stock inlet piping.
c) Disconnect the air flow sensor wire harness.
d) Disconnect and remove the stock inlet piping.
e) Remove the two plastic hold downs on the air inlet funnel.
f) Disconnect and remove the air inlet funnel from the stock air box.
g) Remove bolt holding the stock air box to the mounting bracket.
h) Disconnect and remove the stock air box.
i) Remove the two bolts securing the mounting bracket to the body.
j) Remove the mounting bracket.
k) Remove the 4 nuts holding the air flow sensor to the stock air box.
l) Remove the air flow sensor and set aside as it will be used in the installation of the AEM Intake.
i) Note: Be careful with the air flow sensor as it can be damaged easily. Set the air flow meter aside in a safe place.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,