This kit was designed for use with TM Kit# F4531. Use of this kit with other suspension kits and shocks, including coilovers, has not been verified. Proceed with caution. Interferences may exist. This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal. If the vehicle is suspected to have been in a collision or misused, do not install this kit. Off-road use of your vehicle with this kit installed may increase the stress applied to the factory components. Failure to observe this warning may result in serious personal injury and/or severe damage to your vehicle.
Prepare to Install Shock Hoop
1. Loosen, but do not remove, lug nuts on each front wheel. 2. Using a hydraulic floor jack, slowly lift front axle until front tires are 3-5” off ground. Position jack stands under frame. Lower vehicle onto jack stands while maintaining hydraulic jack pressure underneath front axle. 3. Remove lug nuts and front wheels from vehicle. 4. Driver side a. Remove nut, washers, bushings and shock absorber from upper spring perch

Source pdf for this 2000-2006 Ford F350 Super Duty Dual Shock Hoop Kit Installation Instructions

Related Tags: 2006 ford f350, bushings, caution, coilovers, corrosion, deformation, dual shock, ford f350, ground position, hydraulic jack, interferences, lug nuts, serious personal injury, sheet metal, shock absorber, shocks, source pdf, suspension kits, upper spring, wheels