For rear disc pad removal and installation, DO NOT disconnect brake hose from caliper (wire aside). Replace all pads on an axle if wear indicator on any pad contacts rotor or if pad is worn to within .03″ (.8 mm) of pad backing.
Removal (”A”, “B”, “C”, “K” & “U” Series)
1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Remove wheel. Using “C” clamp, compress caliper piston until it bottoms out in its bore.
2. Remove brake hose from caliper. Remove and discard brake hose gaskets. Plug openings in brake caliper and brake hose in order to prevent brake fluid loss and contamination. Remove caliper guide pin bolts. Remove brake caliper.
Removal (”S” & “T” Series)
1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Remove wheel. Using “C” clamp, compress caliper piston until it bottoms out in its bore.
2. Remove brake hose from caliper. Remove caliper guide pin bolts. Remove caliper from caliper anchor bracket.

Source

Related Tags: anchor, bolts, bore, bottoms, brake caliper removal, brake fluid, brake hose, caliper piston, chevrolet suburban, contamination, disc pad, gaskets, guide pin, master cylinder, pad removal, piston, rear brake caliper, rear disc, rotor, series 1