STEP 1
Roll both front windows completely down and then disconnect the vehicles battery. Read all instructions before proceeding to STEP 2.
NOTE: If you are installing a manual mirror do not disconnect the battery.
STEP 2
Remove the screw from the sail inner trim panel, using a Phillips head screw driver.
WARNING: Do not try to remove the sail inner trim panel after you remove the screw, as it is still connected to the door trim.This panel will be removed in Step 7.
STEP 3
Remove the three screws using a Phillips head screw driver.
STEP 4
Remove the door handle by removing the Torque screw located under the handle.You will need a Torque socket size T40 to remove this screw.
STEP 5
Remove door switch module by levering it upwards with a straight head screwdriver.
STEP 6
Remove all the connectors from the back of the switch module and put the switch module aside.
STEP 7
Using two hands pull up on the door inner trim panel to remove it.
WARNING: Make sure you gently remove the door lock tab, out from the door inner trim panel, before you pull the trim panel away from the door.
STEP 8
Remove the harness from the mirror by unclipping the mirror connector.
NOTE: You will only have this harness if your original mirrors are electric. Undo the three nuts that hold the mirror to the door using a 10 mm socket. After all three nuts have been removed, locate the two white clips near the mirror connector that hold the mirror to the door. Holding the mirror in one hand, unclip the two white clips using a straight head screwdriver, and remove the mirror from the door.
NOTE: There is no need to remove the gasket from the door.
STEP 9
Remove the white plastic stud protector from the mirror. Fit the foam gasket supplied in the installation kit to the base of the new mirror. Feed the red & yellow mirror loose wires into the connector door hole, then slide the mirror onto the door and attach it with the white clips on the mirror connector.
NOTE:When clipping the mirror onto the door make sure you hold the red & yellow wires tight to avoid pinching on the sheet metal.
NOTE:You will only have the red & yellow wires if you are installing an electric/heated with lights mirror variant. Attach the mirror to the door with the nuts supplied. Torque them up to 9NM using a torque wrench and a 10 mm socket.
NOTE: Repeat above steps for other door.

2 IN 1 LIGHT UPGRADE
STEP 10
Remove the front door speaker by removing four Phillips head screws.
STEP 11
Remove the side kick & seal panel (this is in one piece) by levering it with a straight head screw driver and then pulling upwards.
STEP 12
Note:This step is for the LH (driver’s side) only. Remove the top white clip only (revealed in STEP 11) to gain access under the insulation. To remove the clip, first lever it up slightly with a straight head screw driver, then use long nose pliers to lever it out completely.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,