TO START:
1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the mass air sensor wiring from the engine cover.
3. Remove the two screws shown that secure the fresh air tube to the fresh air duct.
4. Pull up firmly on the air filter housing/engine cover assembly to release it from the mounting grommets.
NOTE: The air filter housing/engine cover assembly is still attached to the intake inlet tube.
5. Using pliers, release the spring clamp that secures the intake to the intake inlet. Then unhook the intake tube from the inlet.
6. Remove the air filter housing/engine cover assembly from the vehicle.
6a. Remove the air box mounting stud shown
7. Remove the upper fresh air duct cover as shown.
NOTE: K&N recommends that customers do not discard factory air intake
8. Unsnap and remove the lower fresh air duct as shown.
9. Using a small screw driver remove the two clip nuts from the lower fresh air duct as shown
10. Remove the two screws that secure the mass air sensor to the stock air filter housing and then remove the mass air sensor as shown.
11. Install the mass air sensor into the K&N intake tube with the provided hardware.
11a. Install the tube mounting bracket (070107) onto the K&N intake tube and secure with the provided hardware.
12. Install heat shield #07350 onto heat shield #07351 and secure with provided hardware.
NOTE: Do not completely tighten at this time.
13. Install the third bolt to secure Heat shield #07350 to heat shield #07351 from the bottom side as shown. Completely tighten all three bolts.
14. Install the two heat shield mounting grommets into the mounting holes as shown.
15. On 2007 and later models, it will be necessary to cut and remove the divider from the fresh air inlet tube as shown.
16. Install the heat shield assembly and fresh air duct into the vehicle so that the heat shield mounting grommets are snapped onto the mounting studs and the fresh air duct snaps into the fresh air supply tube, secure the duct and heat shield with the provided hardware.
NOTE: Be sure to snap the lower fresh air duct into the fresh air supply tube. The fresh air duct will bolt to the heat shield.
17. Install the upper fresh air duct cover as shown.
18. Install the provided silicone hose (084016) onto the turbo inlet and secure with the provided hose clamp.
19. Install the tube mounting bracket (010038) onto the left side of the engine cylinder head as shown and secure with the provided hardware.
NOTE: Do not completely tighten at this time.
20. Install the K&N Air Filter onto the K&N intake tube and secure with the provided hose clamp
21. Install the K&N intake tube into the silicone hose at the turbo inlet and align with the bracket installed during step 19. Secure the bracket attached to the intake tube (070107) to the air box mounting location. Secure the intake tube with the provided hose clamp and hardware.
22. Reconnect the mass air sensor electrical connection as shown.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,