2003-2004 (KJ) Jeep® Liberty NOTE: This notification applies only to the above vehicles equipped with Remote Keyless Entry (Sales Code GXM) built from April 1, 2003 through December 12, 2003 (MDH 0401XX through 121200).
The rear flip-up window switch on about 120,000 of the above vehicles may be improperly sealed and could allow water to enter into the switch. This can cause the flip-up window to open unintentionally if it is left unlocked. The rear flip-up window switch must be replaced on all affected vehicles.
Service Procedure
1. Open the rear swing gate.
2. Open the hood and disconnect the negative battery cable. NOTE: To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
3. Using a trim stick, release the push pin fasteners along the bottom and latch side of the swing gate trim panel (Figure 1).
4. Pull the bottom of the trim panel out and then use the trim stick to release the upper trim panel clips. Set the trim panel aside (Figure 1). CAUTION: Use care when releasing the upper clips so as to not damage the trim panel.
5. Pull the swing gate watershield back to access the swing gate handle.
6. Disconnect the swing gate handle flip-up window switch electrical connector.
7. Disconnect the switch harness clip from the swing gate.
8. Stuff a clean shop towel into the gap at the bottom left corner of the swing gate inner space and spread clean shop towels on the bottom of the swing gate inner space.

Source

Related Tags: april 1, caution, clock, customer satisfaction, electrical connector, gap, inner space, Jeep, jeep liberty, latch, negative battery cable, pin fasteners, push pin, remote keyless entry, shop towel, shop towels, swing gate, switch harness, window switch