FITTING
1. Remove Bumper (remove boot floor mat and side storage boxes, remove the 2 nuts inside each wheel arch beneath light clusters, remove the rear plastic panel and the plastic grommets to reveal 1 nut each side, remove nut taking care not to drop it inside. Remove the 2 fixings along the lower edge of bumper and the 3 screws around each wheel arch.
2. Cut Bumper as shown below
3. Remove inner bumper beam complete with mounting arms and discard.
4. Insert Side Arms (D) and (E) into chassis rails (remove tape covering forward mounting points) and loosely attach using Bolts (F). Note: To gain access to forward hole (F) it may be necessary to lower exhaust and heat shield.
5. Loosely attach Cross Bar (A) to Side Arms (D) and (E) using Bolts (G). Tighten all Bolts.
Attach Detachable Neck Kit (ZQ) and Electrical Plate Angle (J) to Cross Bar (A) as per separate instructions, attach Electrical Plate (K) to Electrical Plate Angle using Bolt (L). Tighten bolts. Re-fit bumper.

Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed. Recommended torque settings: M8 – 27Nm, M10 – 53 Nm, M12 – 95 Nm, M14 – 150 Nm, M16 – 214 Nm.

Download

Related Tags: 2 nuts, 2004 audi a6, audi a6, bolts, chassis rails, clusters, cross bar, detachable towbar, fixings, floor mat, heat shield, plastic grommets, plate angle, screws, side storage, storage boxes, torque settings, trailer weight, wheel arch, zq