In your hands is an A-pillar gauge pod that represents the highest degrees of engineering, build-quality, and style. You have chosen a product that was born from the belief auto accessories should adhere to a higher standard. Assembled by hand in the USA, this pillar will give you the satisfaction of owning a custom part instead of the same old thing. The installation of this part should be an enjoyable task, and can be accomplished with minimal mechanical knowledge and basic hand tools. Take a few moments to read these instructions, and you’ll be rewarded with an easy and satisfying installation.

Step One – Removal of OEM A-Pillar
Convertible Mustang:
The factory pillar requires your driver’s sun visor must be removed prior to removing the pillar. Loosen and remove the two screws holding the visor, then remove the sun visor and carefully place aside for reinstallation. Once the sun visor is safely removed, refer the hardtop instructions, as they are very similar once the visor is removed.

Hardtop Mustang:
Your factory pillar is attached to the car with five mounting clips that lock the pillar onto the unibody. To remove the original piece, work your fingers under the edge of the pillar at the rear of the driver’s door. Applying even pressure, pull the pillar away from its mounting point. A firm, slightly quick motion will release the upper clips with ease. Once the upper clips are free, continue to pull the pillar downwards releasing the mounting clips as you work towards the dash top.

source