1. Disconnect the negative battery cable. Loosen the hose clamp on air cleaner box lid. Twist and remove breather hose from air cleaner box lid. 2. Unhook the two air cleaner lid latches on front of box. 3. Remove the air cleaner box lid by sliding it forward, and then up, and out of the factory intake tube. 4. Remove factory air filter from air cleaner box. 5. Remove, and set aside the oil filler cap. Use caution not to drop anything into engine while cap is off. 6. Carefully lift up on the engine cover (it is held in place by grommets, no bolts) to access the hose clamp on the throttle body, and 10mm bolt next to the throttle body. 7. A.) Loosen the hose clamp on the throttle body. B.) With a 10mm socket, remove the bolt next to the throttle body that holds the intake resonator in place. 8. Carefully pull the resonator towards you and rotate the bottom up to gain access to the tie wrap holding the breather hose to the rubber coupler. Cut the tie wrap and discard. 9. Slide the clip off of the resonator that holds the breather tube in place.

Source

Related Tags: 10mm socket, 2005 jeep grand cherokee, air cleaner, air filter, airaid intake systems, bolts, box lid, breather tube, caution, coupler, grand cherokee, hose clamp, intake resonator, intake tube, Jeep, jeep grand cherokee, negative battery cable, oil filler cap, throttle body