1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Depress the locking tab on the mass air sensor electrical connection, then disconnect the\ mass air sensor electrical connection as shown.
3. Release the locking tab and disconnect the crank case vent tube as shown.
4. Loosen the hose clamp, which secures the intake tube to the throttle body, and release the air box over center clips shown.
5. Remove the air box housing half and intake tube as shown.
6. Remove the three body support brace mounting bolts shown and then remove the support brace from the engine compartment.
NOTE: It will be necessary to unhook the cruise control and wiring harness clips from the body brace.
7. Depress the four air box housing retaining clips shown.
8. Remove the upper air box housing from the vehicle as shown.
9. Remove the transmission control module from the housing, release the clamshell retaining clip, and then disconnect the wiring harness as shown.
10. Release the engine control module from the mounting clip and lift the module from the base as shown.
11. Release the engine control module wiring harness clamshell clips and disconnect the wiring harness from the engine control module.
12. Pull up the lower air box housing to release it from the mounting grommets and then remove the housing from the vehicle as shown.
NOTE: K&N recommends that customers do not discard factory air intake.
14. Install the rubber bumpers provided into the engine control module-mounting bracket (26628) as shown.
15. Install the four rubber mounted studs onto the engine control module mounting bracket as shown using the provided hardware.
16. Install the engine control module onto the mounting bracket as shown with the provided hardware.
17. Install the tube mounting bracket (26627) onto the existing transmission stud as shown.
NOTE: It will be necessary to remove the wiring harness retaining clip from the stud.
18. Install the silicone hose (08690) onto the throttle body and secure with the provided hose clamp.
19. Install the provided grommet into the K&N intake tube as shown.
20. Remove the crank case vent fitting from the stock intake tube as shown.
NOTE: This fitting will be reused.
21. Loosen the hose clamp, which secures the stock intake tube to the mass air sensor, and then remove the hose from the sensor as shown.
22. Remove the two screws, which secure the mass air sensor to the air filter housing and then remove the mass air sensor as shown.
23. Remove the “O” ring from the mass air sensor as shown.
24. Install the factory crank case vent fitting removed in step #20 into the grommet installed into the K&N intake tube in step #19.
25. Install the K&N intake tube into the silicone hose at the throttle body and align with the mounting bracket installed in step #17. Secure the silicone hose onto the throttle body with the supplied hardware and hose clamp.
NOTE: Do not completely tighten at this time.
26. Install the silicone hose (08690) onto the mass air sensor as shown and secure with the provided hose clamps.
NOTE: Install the hose so that the arrow molded on the side of the mass air sensor points towards the hose as shown.
27. Install the mass air sensor assembly onto the K&N intake tube as shown and secure with the provided hose clamp.
28. Install the mounting bracket (070952) onto the heat shield with the provided hardware.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,