KIT FEATURES
• DIN Radio Provision with pocket
• ISO Radio Provision with pocket
• Double DIN Radio Provision
• Stacked ISO Units Provision
A) Radio Housing B) ISO Snap In Brackets C) Trim Plate D) Double DIN Brackets E) Double DIN Trim Plate F) Pocket
Dash Diassembly Toyota Rav4
1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unclip and remove the (2) side panels on the left and right side of the factory radio.
3. Remove (4) 10mm screws securing the radio.
DIN MOUNT RADIO PROVISION
NOTE: Refer also to the instructions included with the aftermarket radio.
1. Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward.
2. Slide the aftermarket radio into the cage until it snaps into place.
3. Snap the pocket into the radio housing.
ISO MOUNT RADIO PROVISION
NOTE: Refer also to the instructions included with the aftermarket radio.
1. Mount the ISO Brackets to the radio using the screws supplied with the radio.
2. Slide the aftermarket radio into the radio opening until the side clips snap into place.
3. Snap the pocket into the radio housing.
4. Snap the Trim plate onto the front of the Radio Housing assembly.

Source

Related Tags: 2007 toyota rav4, aftermarket radio, assembly source, battery terminal, brackets, double din radio, factory radio, iso radio, kit features, negative battery, provision, radio 1, radio 2, radio 3, rav4, screws, short circuit, tabs, Toyota, toyota rav4