Vehicle Disassembly for this Toyota Prius.
(a) Lift up the luggage center box cover (rear floor board no. 2). (Fig. 1-1)
(1) Cover the rear trunk edge and bumper with blanket before starting.
(2) Release the lock mechanism from the lock to the unlock position.
(b) Lift up the center luggage box (deck floor box rear). (Fig. 1-2)
(c) Remove the right (passenger) side battery cover (rear floor board no. 3) including the vertical trim cover by separating the four (4) claw fittings. (Fig. 1-3)
(d) Remove the negative battery cable of the auxiliary battery. (Fig. 1-4)
(1) Do not touch the positive terminal with any tool when removing the cable.
(e) Remove the glove box under cover. (Fig. 1-5)
(f) Remove the center cluster under cover. (Fig. 1-6)
2. Microphone Installation.
(a) Using the 3MTM Prep Solvent clean the microphone installation area. (Fig. 2-1)
(1) Always use a clean (lint free scratch resistant) soft cloth (or wipe), and clean a small area at a time (~ 3 ft. x 3 ft. max.).
(2) Shake well.
(3) Apply 3MTM Prep Solvent-70 to cloth or wipe. Do not spray cleaning solution directly on any vehicle surfaces.
(4) Clean surface thoroughly and wipe dry immediately with a new clean cloth. Do not allow cleaner to air dry.
(b) Remove the backing sheet and secure the microphone onto the air duct. (Fig. 2-1)
(1) Do not touch the adhesive surface of the microphone.
(2) Do not cover the opening of the microphone with the foam tape.
(3) Press the microphone to the air duct firmly.
V2 Harness Installation.
(a) Locate the vehicle harness’ white 3P connector from the driver’s side bottom of the center cluster area. Remove the tape from the connector. (Fig. 3-1) (b) Plug in the V2 harness’ white 3P connector to the vehicle harness’ white 3P connector (Fig. 3-2) (1) Verify the connectors are plugged in securely.
(c) Secure the 3P connector to the vehicle harness with one wire tie. (Fig. 3-3)
(d) Plug in the V2 harness’ white 2P connector to the microphone’s white 2P connector. (Fig. 3-4) (1) Verify the connectors are plugged in securely.
(e) Secure the 2P connector to the vehicle harness with one wire tie. (Fig. 3-4)

Source

Related Tags: 2006 toyota prius, air duct, auxiliary battery, center cluster, cleaning solution, deck floor, foam tape, free scratch, glove box, lint, luggage center, max 2, negative battery cable, prius, rear trunk, soft cloth, toyota prius, tvip, vehicle surfaces, wire tie