GUARDIAN MODULE – Remove drivers seat and step-well trim for access. Guardian module should be mounted inside seat pedestal. It can be secured using self-tapping screws or wire ties. Do not secure the module until all harnesses are installed and proper lift operation has been verified.

LED DISPLAY PANEL – This harness can be identified by the blue tape near the 6-pin connector. Locate a suitable position on the dashboard within clear view of the driver for the mounting of the LED Display Panel. LED display harness will be routed under step-well trim (See Fig 2). Drill a ū” hole in the dashboard where you wish the center of the display to be. Snap the blue taped end of the LED display harness into the Guardian Module in the connector labeled in blue “Display”. Run the other end of the harness under the step-well and dash area then through the ū” hole. Snap the other end of the LED display harness into the LED Display Panel. Ensure panel is level, and secure using the supplied screws.
LIFT HARNESS – This harness can be identified by the green tape near the 6-pin connector. Attach the appropriate wheelchair lift adapter to the lift harness, then attach adapter to the wheelchair lift. Run the lift harness from the wheelchair lift to the Guardian Module. Finally, snap the green taped end of the Lift Harness into the Guardian connector labeled in green “Lift”. Before continuing installation, the following check must be performed: Verify that the vehicle ignition is off and the lift is fully stowed for at least 5 minutes. This will ensure the Guardian module is in sleep mode. Attempt to deploy the wheelchair lift. Both the red and green indicators on the LED Display Panel should briefly illuminate as a prove-out after the module wakes up. If they do not, check to make sure each harness is connected to the proper Guardian Module connector as outlined in the above steps. Only proceed to the next step if the indicators illuminate. Otherwise, damage can occur to the module.
VEHICLE 1 HARNESS – This harness can be identified by the orange tape near the 6-pin connector. Locate the parking brake switch circuit (brown with white tracer) on the right side of driver seat pedestal. In a convenient location, cut this circuit. Strip back about ―” of the insulation on each cut side. You will connect the brown wire on the vehicle 1 harness in series with this circuit (See Fig 3). The arrow on this harness must point towards the parking brake switch. If this harness is installed backwards, the unit will not function properly. These connections must be made using solder and the supplied heat shrink tubing. The heat shrink tubing can be cut to 1” lengths for this purpose.

source

Related Tags: , , , , , , , , , , , , , , ,