Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Installation Procedure:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching throttle body to manifold.
4. Lift throttle body.
5. Remove old gasket and clean both throttle body and manifold surfaces.
6. Install power plate with (2) gaskets. (Ref. “A”)
A. Install one gasket between the throttle body and power plate.
B. Install second gasket between the power plate and intake manifold.
7. Install (4) bolts and lock washers (Ref. “B”) using Step 3 as an example.
8. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables may require adjustment. Please refer to your vehicles service manual for proper adjusting.
9. Reinstall air cleaner using Step 2 as an example.
10. Reconnect battery cable. Enjoy!

source

Related Tags: air cleaner, air resources board, bolts, cables, california air resources, california air resources board, dodge dakota, durango, engine compartment, executive order, gasket, gaskets, intake manifold, negative battery cable, power plate, smog inspection, step 2, step 3, throttle body spacer, throttle linkage