Tools required:-vehicle ramp or jack and axle stands, drill and 8.3 or 8.5mm drill bit, T45, T30,T27and T25 torx drivers, 10mm socket/ratchet, 6mm Allen key, Flat blade screwdriver, safety clothing, footwear and eyewear are also recommended.
Raise vehicle and open bonnet/hood. It is necessary to remove the front panel and grill from the front of the vehicle.

To do this firstly remove the four Torx screws from the lower front edge of both wheel arch liners.
Next remove the undertray from the vehicle. Once the screws have been removed the tray is slid to the rear of the vehicle to free it from where it slots into the lower edge of the front panel (bumper cover)
In order to access the bolts hold the front panel to the front wings it is necessary to remove the headlights. Remove the headlight trim panels, these are clipped on the outer edge and slotted on the inner. Once removed you will see a Torx bolt (No.11 in Fig 1 ) on each side that requires removal.
Remove the electrical connectors from the rear of the headlight units and remove the upper and one lower torx screws to a llow the units to be withdrawn.

Download

Related Tags: 6mm, audi tt, bolt, bolts, bonnet, clothing footwear, drill bit, firstly, flat blade, forge motorsport, headlight units, headlights, llow, outer edge, ramp, safety clothing, torx drivers, torx screws, undertray, wheel arch