The NEW BMW 7 Series door lock (Shown Below) – You will not be able to decode the door lock with the tool because the angle of the lock will prevent you from obtaining the correct readings. However, you will be able to decode the boot lock on this model of car successfully.
Note: in some models you have to apply a little bit of force in order to open the car but not to much because excessive force can bend the half key bits.

BMW Precision Car Opening and Decoder Kit
This precision kit was built specially to cater the increasing demand for a solution to the new high security BMW locks. When there is no keys or when the keys are in the car (passenger compartment or boot).

THE KIT CONTAINS:
1) Decoder
2) 16 half keys which cover all combinations
available for all BMW cars
3) Writing charts
4) Solid head
5) Hex screwdriver
Before using the kit please read carefully the instructions. Those instructions will guarantee long term use.
How to use the decoder
THE FOUR GOLDEN RULES TO USE THE KIT:
1) Lubricate the lock
2) Adjust the sleeve
3) Use the decoder gently
4) Use the correct KEY BITS on the CORRECT SIDE

Before putting the decoder in the lock you need to adjust the sleeve to the lock (figure 1) you are about to decode and for that you need to open the two screws holding the sleeve but only a little bit so the sleeve slides easily. Pull the sleeve all the way out and close only one screw then put the decoder in the lock all the way in. Open the screw push the decoder further until the decoder stops and close both screws (figure 2). Then tighten (figure 3).
*Please Note: Adjustment of the sleeve is only necessary if you go from door lock to boot lock.

source

Related Tags: amp, BMW, bmw 7 series, bmw car, bmw cars, combinations, excessive force, figure 1, hex, high security, key bits, little bit, models, new bmw 7, screw, screwdriver, screws