Section 1: Repair instructions for E36 1. Connect DIS/MoDiC 3 tester to a vehicle and read out SRS module fault code memory. If the above mentioned SRS faults are set in the airbag control module, proceed with the repair. 2. Remove corresponding front seat. For a removal instructions refer to RA 52 10 000 , or RA 52 10 001 (sports seat) which can be found in the Technical Information System (TIS). 3. Disconnect vehicle’s battery. 4. Remove cable securing wire ties (1), unplug the belt tensioner connector (2) from the belt buckle assembly and from the seat wiring harness connector. Remove and discard the old belt tensioner ignition circuit harness. 5. Route the seat section of the new harness (P/N 61 12 6 908 853) thorough the seat frame, securing it with four wire ties (2) in loops underneath the seat upholstery (as shown on the illustration). Plug connector (1) into belt tensioner assembly and secure it with wire tie. The other connector (3) should be attached to the seat connector support bracket. Important: make sure that there is no tension in the repair wiring harness, and that the harness does not interfere with the movement of the seat.

Source

Related Tags: belt buckle, belt tensioner, bmw repair, code memory, dis, faults, front seat, harness connector, information system, seat belt, seat frame, seat upholstery, seat wiring, section 1, support bracket, technical information, tis, wire tie, wire ties, wiring harness