Following the instructions procedure:
1. Jack rear of car up on level surface
2. Put jack stands under rear of car under frame area.
3. Remove rear wheels
4. Place jack under rear differential of car with a piece of plywood for support
5. Put pressure on jack to support cradle
6. Loosen cradle nuts (4) total front and rear with a 21 mm socket
7. Lower cradle with jack low enough to install new bushings
8. Spray supplied bushings and mating surfaces with a high quality silicone
9. Install upper supplied cradle bushings. Raise cradle back up to its stock position. Once again making sure you have coated the bushings with Silicone
10. Coat lower set of bushings and install
11. Torque cradle bushings to 140 ft lbs
12. Install rear wheels back on car
13. Set car back on ground and torque wheels to 90 Ft lbs

source

Related Tags: Cadillac, cadillac ctsv, differential, frame area, ft lbs, high quality, level surface, nuts, plywood, rear differential, rear wheels, silicone, socket 7, stock position, surfaces, torque