This Blow-off valve kit is specifically designed to fit a standard engine. If your engine has non-standard intercooler piping this kit may require modification. IMPORTANT NOTES ON KOMPACT DUAL PORT BOV FITMENT TO AUDI V6 BI-TURBO AWD Turbosmart recommends that your Blow-Off Valve (BOV) is fitted by an appropriately qualified technician.
(more…)

• 0 Comments

OPi-A8 is a direct iPodо interface developed for Audi vehicles utilizing the MOST fiber optic bus. OPi-A8 is designed to interface with current versions of the iPodо and iPodо Nano. Once installed, OPi-A8 allows the ability to control iPodо functions from the vehicle’s head unit, and also allows partial control of iPodо functions (volume adjustment and track control) from the vehicle’s steering wheel controls. To minimize driver distraction, the iPodо interface buttons will not respond while the iPodо is docked and the OPi-A8 is active. While the iPodо is docked with the OPi-A8 interface, the iPodо will automatically begin charging. In order to activate the OPi-A8 your radio must be in CD changer mode. Vehicles equipped with factory installed CD changers will lose the function of the CD changer once the OPi-A8 is installed. Vehicles that do not have a factory installed CD changer will not lose any radio functions.
(more…)

• 0 Comments

TO START:
1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the mass air sensor wiring from the engine cover.
3. Remove the two screws shown that secure the fresh air tube to the fresh air duct.
4. Pull up firmly on the air filter housing/engine cover assembly to release it from the mounting grommets.
NOTE: The air filter housing/engine cover assembly is still attached to the intake inlet tube.
5. Using pliers, release the spring clamp that secures the intake to the intake inlet. Then unhook the intake tube from the inlet.
(more…)

• 0 Comments

All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
Locate four slots on the face of the radio. Insert four Audi DIN tools in these four slots until you hear or feel the tools click or lock.
(more…)

• 0 Comments

Bob and I appreciate your purchase of your HyperBoost Valves from Stratmosphere. Please read these instructions prior to installation so that you can enjoy a simple and quick installation of your new HyperBoost valves!

Step 1- Remove motor cover
This is the small triangular cover in the front of the engine where the dipstick is located (figure 1). Just twist the two screws 90 degrees counterclockwise. Then lift up the cover. The cover fits onto a rubber round mount at the point on the “triangle” as well. It’s just pressed on there.
(more…)

• 0 Comments

With the purchase of this SCHROTH asm harnessbelt, you have chosen a sophisticated restraint system, which represents a further advance in harness restraint technology. Extensive research, testing and field experience has shown it to offer, when properly installed and worn, high levels of protection in head-on collisions.
(more…)

• 0 Comments