This shock is pressurized to 250 psi nitrogen. This pressure is not an adjustable feature of the shock. Unless there is a leak, the shock should not normally lose pressure. If the shock damping becomes soft or mushy (after an extended period of time or number of miles) the shock may need to be serviced which includes shock oil and a nitrogen charge. In this situation, re-pressurizing the shock alone may not improve the action of the shock. The shock should be returned to Works Performance Products, Inc., or to a qualified shop that has the appropriate tools, training and nitrogen handling equipment.
(more…)

• 0 Comments

The instructions step:
• Place the bike on the center stand and remove the current shock absorber.
• Place the Hyperpro shock in the bike, type 461 with reservoir as shown in the picture. If your shock is equipped with the optional hydraulic preload adjuster place the banjo bolt of the HPA to the right side of the bike.
• Use the two added clamps and rubber blocks to mount the reservoir on the sub frame
(more…)

• 0 Comments

This mount bar has been designed to provide a mounting point for the shoulder straps of a 5 or 6 point off road harness system. Note: loctite on all threads is recommended. Steps (1 – 7) are for installing the rear mounting brackets. These brackets remain in the vehicle so these steps are done just once.
Step 1. Remove rear lower seat cushion lift up at lower edge as shown.
Step 2. Remove outside seat back cushions. Carefully pull at top rear edge, rotate & pivot to clear lower pivot pin.
Step 3. Remove rear inside 1/4 panels carefully – pop out.
Step 4. Remove outside rear seat belt buckle, mounting bolt and washers.
(more…)

• 0 Comments

These installation instructions are mainly intended for use in the MINI dealership network and by authorised BMW Service Centres. The target group of these installation instructions are technical personnel trained on MINI vehicles with corresponding technical know-how.
All work is to be carried out with the aid of currently valid MINI repair instructions, schematic circuit diagrams, maintenance manuals and working instructions in rational order with the specified tools (special tools) while paying particular attention to valid safety regulations.
(more…)

• 0 Comments

SCHROTH BMW specific asm-Rallye 4 Series harnessbelts are only intended for installation at the left and right outboard front seating positions of designated BMW and MINI model passenger cars which have been specifically evaluated by SCHROTH engineers for anchor point locations and suitability of available front seats. Before attempting installation, please first answer the following questions and carefully follow the instructions which accompany them.
(more…)

• 0 Comments