Trail Master recommends this system be installed by a certified technician! These instructions address installation of the Trail Master system and may not include OE recommended procedures for disassembly / reassembly of OE components. Research the areas requiring certification. In addition to these instructions, professional knowledge of disassembly / reassembly procedures as well as post installation checks are required. Attempts to install this system without knowledge and expertise may jeopardize the integrity and or operating safety of the vehicle.
(more…)

• 0 Comments

Gibson RM Pty Ltd thanks you for your purchase and the trust you put in our products. We strive to supply our customers with the highest quality equipment based on the most efficient design and best styling. We are confident that you will enjoy using our Snorkel system. It should improve the power of your vehicle as well as reduce its fuel consumption.
(more…)

• 0 Comments

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection.
3. Pull firmly up on the engine cover to remove.
4. Loosen the hose clamps on the air intake tube at the throttle body and air box.
5. Disconnect the crank case vent from the valve cover.
6. Remove the air intake hose and crank case vent from vehicle.
7. Lift firmly up on the air box to remove from the car.
8. Remove the stock air box grommets from the stock air box mounting tray.
(more…)

• 0 Comments

Installation Instructions
Note: If you are not familiar with this type of installation, you may want to consult a Service Trade Manual. The manual will also provide you a complete listing of torque specifications. Your Chrysler starter will bolt into place without any modifications. You will need to modify the transmission bellhousing to gain needed clearance for the starter nose.
(more…)

• 0 Comments

Before installing the MSD Digital E-Curve Distributor, disconnect the battery cables. When disconnecting the battery cables, always remove the Negative (-) cable first and install it last.
The terminals of this Digital E-Curve Distributor require spark plug style terminals. You may need to change the terminals and boots of your wires. MSD offers two kits, PN 8849 or PN 8848 that are supplied with nine boots and terminals.
(more…)

• 0 Comments