Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary to remove the wheels depending on the tools being used for installation.
Clean and degrease the mud guard location area on the fender before installation.
1. Remove existing fasteners from locations A, B, and E (Figure 1).
2. Install a u-clip at location E.
3. Install the mud guard with small #8 screws and washers at locations A and B. Check fit and parallel and adjust accordingly before tightening.
4. Install #10 screw and washer at location E.
5. Using the mud guard as a template, drill a 1/8” hole at location D (Figure 1).
6. Install a #10 screw and washer at location D.

PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
PAINT PROTECTION FILM INSTALLATION INSTRUCTIONS
NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting surfaces of your fenders against wear. The templates (left and right side) can be removed from the backing liner by folding the liner at the center cut of the template, separating the film sides and peeling the film templates from the backing liner.

source

Related Tags: adhesion promoter, Chevrolet, chevrolet silverado, dirt, fasteners, fender, fenders, film installation, grit, location area, mud guard, paint manufacturer, paint protection film, sand painting, sand paper, screw, screws, soap and water, washers, water solution