Follow carefully the instructions listed on these pages and use the template provided, do not over tighten bolts. Do not use silicone on any connections, use urethane Ensure that safe work practices are followed when installing your Airflow Snorkel. Protective ear and eye wear should be worn at all times when using power tools.

It is highly recommended that installation is undertaken by a qualified mechanic or panel beater. Gibson RM Manufacturing will not be held responsible for any damage incurred through incorrect fitment of the templates and workmanship. It is the responsibility of the fitter to ensure that particular care is taken when assembling the Snorkel kit to the vehicle as it may cause damage to the windscreen and or electrical components. Safe work practices must be used at all times when undergoing installation. We guarantee Airflow Snorkel kits against manufacturing defects as long as proof of purchase can be established.
All models produced by Airflow Snorkels are verified to suit right hand drive vehicles according to Australian specifications. Variations in vehicle specifications may occur in other markets.

List of tools and additional parts required
Masking tape, Clear tape, Urethane
Hammer, Centre punch
Assorted screw drivers
76mm hole saw
Assorted drill set
Wet / dry sand paper
½ round file, Small square file
Zinc rich primer
NOTE: It may be necessary to purchase new single use plastic rivets fixings from Chrysler Jeep if the inner guard fixings are damaged

source

Related Tags: , , , , , , , , , , , , , , , , , , ,