Installation:
If the vehicle has a VES (Video Entertainment System), it must be disconnected! This interface is not compatible with REF model radios. They do not have a VES input available.
1. Remove factory radio. Remove factory female 10 pin Satellite cable, if available. Plug the CHYP’s 10 pin SAT plug into the radio. Plug the factory Satel- lite cable that was just removed into the CHYP’s 10 pin connector.
2. Insert the CHYP’s 22 pin main power Plug (T-Harness) in between the factory radio and factory harness.
3. If the vehicle has both factory Satellite and VES, you must disconnect the VES at the overhead unit. The Satellite radio will still be available for use. If the vehicle has factory single disc radio (REF), this interface is NOT compatible. Refer to vehicle’s repair manual for location and removal of the VES plug.
4. The CHYP output plug (3 pin connector) must be connected to the VES input harness of the 10 pin T-harness (Purple, Black, Green).
5. To activate IPOD mode, press the MODE button until VES is selected. If the IPOD is the desired source, it must be connected to the supplied cable BEFORE the source (VES) is selected. If it is not, Chp 2 will automatically be selected (Aux mode)
Chp 1 – IPOD mode
Chp 2 – Auxiliary mode
Note: The CHYP will emulate the VES only! If the vehicle has factory VES it MUST be disconnected. VES does NOT operate in R.A.P. mode. The radio will automatically switch to tuner mode during R.A.P. (Retained Accessory Power)
The RED wire with fuse holder: This wire provides a +12 volt output when key is in accessory or ignition position. The output is 1 amp max. Insulate end if not used. Warning! Do Not connect this wire to the vehicle’s accessory/ ignition wiring.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,