The Mag-Hytec pan is designed to fit the factory Dodge #727 transmission body as supplied as original equipment. However, in some applications, or because of the use of certain factory options and/or after market equipment, there may be clearance problems between your Mag-Hytec pan and other vehicle components. It is the responsibility of the vehicle owner and installer to ensure that there is no contact between the pan and other moving or fixed vehicle components. Contact with any vehicle component or the modifying of the Mag-Hytec pan voids the warranty. Mag-Hytec assumes no liability, expressed or implied, for damage or injury to persons or property.

Installation:
1. Park your vehicle on level ground and apply the parking brake. Use jack stands if the vehicle must be raised.
2. Position a large drain pan under the transmission to catch the fluid. Also drain the torque converter.
3. Starting at the rear, remove the 14 existing pan bolts.
4. Using a gasket scraper, start at the rear of the pan and carefully (so as not to gouge the transmission case) insert between the existing pan and transmission housing and pry the old pan off.
5. Allow all of the old oil to drain.
6. Using a gasket scraper, carefully remove all of the old gasket material (dried silicone) from the transmission case.
7. Use clean lint free rags to clean the transmission case gasket surface. The surface must be clean and flat for the gasket to seal.
8. Before installing the new Mag-Hytec pan, check the gasket matting surface on the transmission case for dents, irregularities, or gouges. Should any exist, carefully remove the high spots using a smooth flat file. BE CAREFUL NOT TO “ROUND OFF” THE FLAT GASKET SURFACE.
9. Remove the filter and replace it with a Dodge filter (Dodge Part #3515996 up through ‘97, Part #52118789 for ‘98’s and up). A Transtar Part #3859F gasket is preferred for all 727 bodies. (The cork or rubber gaskets do not work well with aluminum to aluminum)
10. Apply a thin layer of ATF trans oil to the Mag-Hytec Drain plug O-ring.
11. Align the bolt holes and install the 14 cap screws and washers until they are installed “finger tight.”
12. Using a 1/4 hex bit and 3/8 drive torque wrench, torque the zinc plated allen cap screws to (12-16 ft. lbs.) in a “cross tight” pattern.
13. Check the drain plug and 1/8 pipe plug for tightness. If you are going to install a temperature sender, do so at this time. Remove the 1/8 pipe plug and install the sender in its place. Be Sure To Use LPS All Purpose Anti-Seize or equal On The Sender’s Pipe Threads. “TIGHTEN” both the DRAIN PLUG and 1/8 PIPE PLUG TO (30 in. lbs) DO NOT OVER TIGHTEN.
14. Remove the dipstick and add in the new ATF or (“LE” 7500 Monolec Power Fluid for severe and HD applications). The Mag-Hytec 727-DD (Double Deep pan) holds 9 qt’s. of oil . 4 quarts of oil over a stock 96 pan. Fill to full line on dipstick.

source

Related Tags: , , , , , , , , , , , , , , , , , , ,