The Model 501902-31xx is a pair of LED light heads for the back up light section of the 2006 Dodge Charger tail lamp housings. The LEDs utilize polycarbonate TIR Collimators and Fresnel lenses for maximum light output. These units are designed for use ONLY with Federal Signal Corner LED electronic flasher, Model 501903. The unit is supplied with mounting hardware. It has an operating temperature range of -40°C to +65°C.

After unpacking the kit, inspect it for damage that may have occurred in transit. If the unit has been damaged, do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of damage. Carefully check all envelopes, shipping labels, and tags before removing or destroying them. Ensure that the parts listed in the appropriate KIT CONTENTS LIST are included in the package.

INSTALLATION.
Installation can be accomplished using the supplied hardware. The light heads come with AMP or Weather-Pack connectors and may be used with the appropriate Federal Signal Ricochet Cable Kits. The basic light functions of the unit must be controlled by a user-supplied Federal Signal Corner LED electronic flasher, Model 501903. Before drilling holes in ANY part of vehicle, be sure that both sides of the mounting surface are clear of parts that could be damaged, such as brake lines, fuel lines, electrical wiring or other vital parts. Connecting these LED light heads to a strobe power supply will result in immediate failure of the LED light heads and may damage the strobe power supply.
1. Following the directions in the vehicle manufacturer’s service manual, remove the tail lamp assemblies.
2. Cut out the included hole templates. See figure 1. Position the templates as shown, centered front to back, and mark the hole centers. Drill the three 1-1/2” holes using a hole saw, then drill the two 5/32” holes. Deburr all the holes, then thoroughly clean the housings to remove all chips.
CAUTION
The surfaces to which the adhesive gasket is applied must be clean and dry for proper adhesion. If necessary, use isopropyl alcohol (rubbing alcohol) and water to clean the mounting surface.
3. Peel the backing from one side of the gasket and apply the gasket to the LED light head. Peel the remaining backing and insert the LED light head into the housing.
CAUTION
Do not over-tighten the screws.
4. Install the supplied screws using care not to cock the LED light head.

source

Related Tags: backup light, cable kits, collimators, dodge charger, drilling holes, electrical wiring, federal signal, fresnel lenses, fuel lines, kit contents, labels and tags, light functions, maximum light output, shipping labels, strobe power supply, supply 1, tail lamp, temperature range, vehicle manufacturer, weather pack