BMW Quick Start Installation (for Dual-plugged heads and non-stock ignition advance, models 1981-1995 with factory electronic ignition systems, see the full Installation & Troubleshooting Guide).
1. Open black box (part #1), set dip switches according to sticker (part #10). Apply sticker to top.
2. Attach black box (part #1) to aluminum plate (part #5) with bolts and washers (parts #11).
3. On 1970-78 models, remove mechanical advance unit. For 1979-1980 models, remove bean can.
4. Remove rotor bolt, replace with replacement bolt (part #14), timing wheel (part #3) and hub (part #6). The wheel is attached so the “N” and “S” stamps face out. Torque rotor bolt to 168 in-lbs.
5. Install trigger unit (part #2) under top and right stator bolts. Torque to 36 in-lbs.
6. Install black box under the tank where the voltage regular used to be (eliminated with the EnDuraLast alternator installation) using bolts and washers (part #12). Connect black box to trigger unit, tidy up with cable ties (part #9).
7. Connect black box wires according to laminated wiring diagram (part #7). Use extra spade terminals (part #8) as needed.
8. Turn engine to TDC.
9. Loosen 3 set screws with wrench (part# 4): LED
10. With ignition on, rotate wheel clockwise as viewed from the front of the engine. As the wheel rotates, the LED on the trigger plate will turn ON when the “S” stamped on the wheel passes the trigger. It will extinguish when the “N” on the wheel passes the trigger. Slowly rotate the wheel until the LED just turns off. Tighten the 3 set screws. This is the initial timing setting.
12. Bend pointer (part #17) as shown:
11. Start engine, rev > 3000 RPM, verify “F” mark location with timing light. Loosen set screws on timing wheel and rotate to correct. Verify with timing light. Tighten set screws with blue Loctite.
13. Apply 5 mm strip from the sticker (part #10) to end of pointer.
14. Remove indicated screw on trigger, slide on the pointer, replace screw.
15. Turn engine to TDC. Install degree wheel sticker so pointer points to “OT”.

source: http://www.euromotoelectrics.com/v/vspfiles/assets/images/edl-ign-quick-start-v1.1.pdf

Related Tags: , , , ,