This kit provides the SOLUTION for eliminating cruise control on throttle bodies found in the 02-06 RSX-S and 02-05 Civic Si while:
-Enabling usage of a short OEM throttle cable (Acura 17910-ST7-L01) for swap cleanliness
-Eliminating throttle cable/bracket interferences (with fuel lines, hoods, hoses, etc.)
-Essentially converting a K20A2/A3/Z1 throttle body into a K20A (Type R) throttle body
-Comprised of high quality billet 6061-T6 machined aluminum.

MODIFYING THE GSR THROTTLE CABLE
1. Obtain a 94-01 Acura GSR throttle cable (Acura P/N: 17910-ST7-L01).
2. Slide the metal retaining ring off of the throttle cable boot.
3. Use wire-cutting pliers to cut a slit in the retaining ring for removal from the throttle cable. Be cautious not to damage the throttle cable wire when cutting
4. Use scissors to trim your throttle cable boot as shown. The area to cut is after the second bellow, leaving three bellows remaining on the boot. Again, make sure not to allow the scissors to mar the steel braided throttle cable wire.

CRUISE CONTROL REMOVAL
1. Remove the two M6 factory throttle cable bracket bolts with a 10mm socket. Discard the factory throttle cable bracket, but retain the M6 bolts for later use.
2. Remove the M7 nut and lock washer on the front of the throttle body rotor with an 11mm socket and retain for later use.

source

Related Tags: 10mm socket, bellows, cable wire, cruise control, fuel lines, hoods, hoses, interferences, l01, lock washer, m6, machined aluminum, pliers, quality billet, retaining ring, rsx, throttle bodies, throttle body, throttle cable, z1