1. Vehicle Disassembly. (a) Remove the negative battery cable. (Fig. 1-1) (1) Protect the fender before starting. (2) Do not touch the positive terminal with any tool removing the cable. (b) Remove the glove box under-dash cover. (Fig. 1-2) (c) Remove the passenger’s step cover. (Fig. 1-3) (d) Remove the passenger’s cowl cover. (Fig. 1-4) (1) Remove one nut securing the cowl cover. (e) Remove one screw and one bolt from the glove box assembly. (Fig. 1-5) (f) Remove the glove box assembly. (Fig. 1-6) (1) Open the glove box door and remove three screws securing the glove box assembly. (2) Disconnect the trunk opener cancel switch from the glove box assembly if equipped. For vehicles with Smart Entry, the disassembly process ends on Step f. Go to Section 5. For vehicles without Smart Entry, continue the disassembly process. FOR VEHICLES WITHOUT SMART ENTRY SYSTEM ONLY. (Step g) NOTE: Do not perform this step if the vehicle has (more…)

• 0 Comments

STEP 1. Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece. Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do not disconnect the wiring . STEP 2. Under the temperature control module is a small black panel that is held in (more…)

• 0 Comments

Dash Assembly: 1 Disconnect the negative battery-terminal to prevent an accidental short circuit. 2 Unsnap the trim below the climate control to reveal (2) 10 MM bolts and remove. (Figure A) 3 Carefully pull air vents above radio towards rear of car to unsnap. NOTE: There are (3) snaps, (2) are at the bottom sides and (1) is at the top middle of the vent assembly. (Figure B) 4 Remove (2) 10 MM bolts from above radio/climate control assembly. Unplug and remove assembly together. (Figure C) 5 Remove (6) Phillips screws (4 from radio and 2 from climate control) from each side bracket to separate radio and climate control. (Save climate controls and brackets to reuse during kit assembly). (Figure D) Continue to kit assembly.
(more…)

• 0 Comments

The information contained in this TSB supersedes TSB No. ST001-06. • Applicability has been updated to include 2005 – 2006 model year Avalon and 2006 model year Highlander HV. • Production Change information has been removed. • The Introduction, Warranty Information, Parts Information, and Repair Procedure sections have been updated to reflect removal, lubrication, and reinstallation of the steering intermediate shaft instead of replacement. TSB No. ST001-06 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.
(more…)

• 0 Comments

Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the “Accessory Installation Practices” document. This document covers such items as:- • Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.). • Safety (eye protection, rechecking torque procedure, etc.). • Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). • Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.).
(more…)

• 0 Comments

Installation Preparation A. Check Kit Contents 1. Check kit for contents and damage. B. Vehicle Preparation 1. Use blankets to protect the front grille area and STOP the front seat area. 2. Set parking brake. STOP 3. Disconnect negative battery cable from battery. C. Removal Procedure: Air Filter Enclosure Assy. 1. Disconnect the Mass Air Flow (MAF) sensor connector from the MAF sensor. (Fig. C1) 2. Separate the fuel vapor feed hose and fuel vapor feed hose No.1 from the Vacuum Switching Valve (VSV) assembly. (Fig. C1, top-left detail) 3. Remove the VSV (more…)

• 0 Comments

Instruction manual for toyota yaris from Blitz Performance. This kit was produced for a standard stock car. In the case where this kit is installed on a vehicle other than stock, we are unable to guarantee its functional efficiency and durability of the product. Please be careful when installing this product, whereas no foreign objects or liquids get into it. The result of foreign materials getting mixed into the products may cause malfunctions in the products. During installation, in case of any uncertainties, it is important to have a factory service manual at hand. (more…)

• 0 Comments

This service bulletin is to inform you on how to handle “DTC P0420 / P0430″ cases for Yaris, Previa / Tarago, RAV4, Avensis Verso / Picnic. DESCRIPTION OF PHENOMENON • Engine MIL ON. • Code P0420 or P0430 in the engine ECU. • No influence on driveability or engine performance.
(more…)

• 0 Comments

2003 – 2005 model year Matrix vehicles produced BEFORE or AFTER the VIN shown below. Part numbers vary based on Matrix vehicles produced before or after the VIN (refer to the Parts Information table in this TSB). Front Doors Repair Procedure Refer to steps 1 – 6 in the Technical Information System (TIS): 2003, 2004, or 2005 model year Matrix Repair Manual: Engine Hood/Door: Front Door: Overhaul.
(more…)

• 0 Comments

Upper Windshield Glass Stoppers: 1. Remove both sun visors and both A-pillar garnishes, and then carefully lower the front of the headliner to gain access to the windshield stoppers (refer to the appropriate model year Repair Manual for the proper procedure). NOTE: It is very important that the front of the headliner be lowered carefully and slowly. Applying too much downward force on the headliner will cause it to develop a permanent crease in the surface material. The stoppers are located on the inside of the passenger compartment behind the windshield glass (more…)

• 0 Comments