Removal 1. CAUTION: The No. 1 cylinder must be set on top dead center (TDC) of the compression stroke or the synchronizer assembly will not be installed correctly. CAUTION: Do not turn the crankshaft or the camshaft during the removal and installation procedure or the fuel system timing will be out of time with the engine and possibly cause engine damage. Rotate the crankshaft until the No. 1 cylinder is at TDC of the compression stroke and the TDC mark lines up with the timing mark.
(more…)

• 0 Comments

You will have bolts/nuts left over. There are several vehicle arrangements and we have provided the hardware for each configuration.
STEP ONE: Determine proper bracket placement.
1) Find the pre-existing holes equally spaced on the pinch weld.
2) Factory mounting holes have changed throughout model years and will require one of the following. ( Fig A & B )
(more…)

• 0 Comments

The 555P interface module is used when installing remote start products in Ford vehicles equipped with a factory immobilizer. The 555P allows for easy interfacing between the remote start and the factory immobilizer, while maintaining the integrity of the OEM system.
(more…)

• 0 Comments

The Ford – Ignition Start Control’s (ISC) will prevent start-up backfire during alternate fuel operation. The controller delays the ignition until the Ford OEM computer synchronizes with the cam sensor and generates no waste spark.
(more…)

• 0 Comments

This manual contains information and procedures for towing Ford Motor Company passenger cars and light trucks using slingbelt wrecker equipment. CAUTION: To avoid personal injury and/or vehicle damage, carefully follow procedures in this manual.
(more…)

• 0 Comments

The information found in this guide was in effect at the time of printing. Ford may change the contents without notice and without incurring obligation.
WARNING LIGHTS AND CHIMES
Low fuel
Illuminates as an early reminder of a low fuel condition indicated on the fuel gauge. The light comes on when there is approximately 1/16th of a tank indicated on the fuel gauge (refer to Fuel Gauge in this chapter for more information). The ignition must be in the ON position for this lamp to illuminate. The lamp will also illuminate for several seconds after the ignition is turned to the ON position regardless of the fuel level.
(more…)

• 0 Comments

This guide describes the scheduled maintenance required for your vehicle. Carefully following this schedule helps protect against major repair expenses resulting from neglect or inadequate maintenance and may also help to increase the value of your vehicle when you sell or trade it.
(more…)

• 0 Comments

Refer to Wiring Diagrams Cell 55, Electronic Automatic Temperature Control (EATC) for schematic and connector information.
1. Verify the customer’s concern by operating the climate control system to duplicate the condition.
2. Inspect to determine if one of the following mechanical or electrical concerns apply:
Visual Inspection Chart
(more…)

• 0 Comments

Parrot MULTICOMM is a unit able to control Parrot H/F kits with the car’s steering wheel commands working with ANALOG STEERING WHEEL COMMANDS with OEM headunit installed.
This unit is available in two versions, one working with the CK3000 Evolution, another for the CK3100.
(more…)

• 0 Comments

Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
(more…)

• 0 Comments