This Borla Performance Rear Section Exhaust System (Part number 11762) has been designed for 2008 Nissan Altima equipped with a 3.5L V-6 engine and automatic or manual transmissions.
Original Exhaust System Removal
(more…)

• 0 Comments

Nissan has determined that some 2000-2003 model year Nissan vehicles may have a defect which relates to motor vehicle safety. The engine might stop running while being driven if the crank position sensor or cam position sensor fails. This may also result in the “Service Engine Soon” light coming on or reduced engine power. If the engine stops running while driving, this could result in a crash without warning.
(more…)

• 0 Comments

This paper investigates detection of an air leak fault in the intake manifold subsystem of an automotive engine during transient operation. Previously, it was shown that integrating the local approach with an auto-associative neural network model of the engine, significantly increased the sensitivity of fault detection. However, the drawback then is that the (more…)

• 0 Comments

1. For ease of installation of your Banks Ram-air intake system, familiarize yourself with the procedure by reading the entire manual before starting work. This manual contains 16 pages of copy, illustrations and parts listing. If any pages are missing from this manual please call Gale Banks Engineering immediately for a replacement.
(more…)

• 0 Comments

Before servicing propeller, be sure the engine is in neutral with ignition off or disconnected to avoid any possibility of the engine starting and causing injury. Do not install any propeller without a thrust washer in place. If a thrust washer is not used, severe damage could occur to the propeller and/or engine drive. For Nissanо and Tohatsuо 40C, 40D, and 50D models: (more…)

• 0 Comments

Installation Instructions for: Part Number 21-546 2002-2006 Nissan Altima 2.5 Only for Engine Family # 5NSXV02.5G5A. The AEM Cold Air System is the result of extensive development on a wide variety of cars. Each system is engineered for the particular application. The AEM Cold Air System differs from all others in several ways. We take the inlet air from (more…)

• 0 Comments

Before the installation remove the keys from the ignition Remove the engine cover. Locate the fuel injection pump. The pump is under the engine cover on the left side, behind the engine. Disconnect the 9 pin plug on the injection pump and connect (more…)

• 0 Comments

Clean diesel technology can help to improve Tehran’s environmental and air quality. Reducing emissions from existing diesel engines with the existing technologies provides one of the most cost- effective solutions to achieve real and immediate air quality benefits. Diesel engines are significant contributors to air pollution. In order to reduce air pollution, diesel engines can be retrofitted with after- treatment pollution control devices to achieve sufficient reductions. Many retrofit (more…)

• 0 Comments

1. When you doing the camshaft on Nissan GA16DE installation, it is highly recommended that an oil and filter change be done before installing new cams.
2. Remove the distributor, and valve cover from the engine. Use caution not to drop anything into the engine.
3. With the parking brake on, and the car out of gear (neutral), rotate the crankshaft clockwise until #1 cylinder is at TDC (more…)

• 0 Comments

1. It is highly recommended that an oil and filter change be done before installing new cams.
2. Remove the plug wires, and valve cover from the engine. Use caution not to drop anything into the engine.
3. With the parking brake on, and the car out of gear (neutral), rotate the crankshaft clockwise until #1 cylinder is at TDC (more…)

• 0 Comments