1. Disconnect the negative battery terminal.
2. Unclip and remove the electrical plug from the MAS (Mass Air Sensor).
3. Remove the two screws securing the resonator tube to the air box lid.
4. Unclip and remove the intake hose from the MAS.
5. Undo the 2-air box mounting bolts and remove the air box from the vehicle.
6. Unbolt and remove the rear gearbox-mounting bolt as shown.
(more…)
The blue indicator light goes off Pull and release the headlight switch to flash the headlight high beams on and off TURN SIGNAL SWITCH Move the headlight control switch up or down to signal the turning direction When the turn is completed the turn signals cancel automatically To signal a lane change move the headlight control switch up or down to the point where the indicator light begins to flash but the headlight control switch does not latch FOG LIGHT OPERATION if so equipped Note The headlights must be on and the low beams selected for the fog lights to operate Turn the switch to the position to turn on the fog lights Turn the switch to the OFF position to turn off the fog lights (more…)
Make sure you maintain the vehicle in a clean pristine condition, and trim components are undamaged and placed back into position. Always protect the painted and interior surfaces, on all vehicles during the installation. Have a clean terry cloth and cleaning alcohol with you to clean off any fingerprints on the interior of the vehicles. Note: The 2008 TT is currently the only vehicle that can be ordered with CD Changer prep or CD Changer. The 2008 R8 must have a CD Changer to accommodate this installation.
(more…)
1. Disconnect the negative terminal from the battery.
2. Remove the plastic cover from the air box assembly.
3. Remove the air box feed pipe from between the air box lid & slam panel intake scoop.
4. Unclip & remove the electrical harness plug from the MAS (Mass Air Sensor).
5. Unclip & remove the intake hose from the MAS.
6. Unclip the 3 hoses from the top of the air box assembly.
7. Unbolt & remove the two ignition amplifiers from the top of the air box lid.
(more…)
To determine the Gross Trailer Weight weigh your trailer on a scale with all equipment and cargo that are normally in the trailer when it is towed Make sure the Gross trailer weight is not more than the Gross Trailer Weight Rating shown on the trailer and is not more than the calculated available maximum towing capacity.
(more…)
1) Remove the (3) screws holding the plastic bumper fascia to the bottom of the trunk pan.
2) Remove the spare tire and jack from inside the trunk.
3) Remove the (2) rearmost plastic drain plugs from the bottom of the trunk pan.
4) Using the rotary cutting tool, remove material from the lower part of the plastic fascia as shown in the Fascia Trim Detail above.
5) While gently pulling the fascia down and rearward, install the bolt plates and 1/2-13 x 4 1/2 long carriage bolts on top of the bumper support tubes.
(more…)
Congratulations on your purchase of the AWE Tuning Front Mount Intercooler for your Audi. Hundreds of hours of design and operational testing were spent to ensure maximum results without compromise. You have truly selected the best performing intercooler kit for the 2.0T engine. While the install is fairly straight forward, please review these instructions carefully before attempting installation. If you do not feel comfortable installing this kit on your own, contact a professional installer in your area.
(more…)
Remove dirt with a vacuum cleaner or broom Appearance and care 7 5 REVIEW COPY 2005 Xterra xtr Owners Manual USA English nna 01 26 05 tbrooks MEMO 7 6 Appearance and care 8 Maintenance and do it yourself Maintenance requirements 8 2 General maintenance 8 2 Explanation of general maintenance items 8 2 Maintenance precautions 8 5 Engine compartment check locations 8 6 Engine cooling system 8 7 Checking engine coolant level 8 7 Changing engine coolant 8 8 Engine oil 8 8 Checking engine oil level 8 8 Changing engine oil 8 9 Changing engine oil filter 8 10 5 speed automatic transmission fluid 8 11 Power steering fluid 8 11 Brake and clutch fluid 8 11 Brake fluid 8 12 Clutch fluid 8 12 Window washer fluid 8 12 Window washer fluid reservoir 8 12 Battery
(more…)
Common Problems
1. I am having trouble connecting with an ‘02 Audi A4.
This vehicle does pose connection issues with most aftermarket tools. Please continue to retry the connection.
2. I am having trouble getting good data rates on a specific controller.
Audi/VW consolidated sensors into groups. Some sensor groups can update at slower rates then others. Typically, this is text-based sensors on non-critical models like Telephone or Climate control. To resolve this select only those sensors that are important to you until you reach a saturation point for the data throughput.
(more…)
FITTING
1. Remove Bumper (remove boot floor mat and side storage boxes, remove the 2 nuts inside each wheel arch beneath light clusters, remove the rear plastic panel and the plastic grommets to reveal 1 nut each side, remove nut taking care not to drop it inside. Remove the 2 fixings along the lower edge of bumper and the 3 screws around each wheel arch.
2. Cut Bumper as shown below
3. Remove inner bumper beam complete with mounting arms and discard.
4. Insert Side Arms (D) and (E) into chassis rails (remove tape covering forward mounting points) and loosely attach using Bolts (F). Note: To gain access to forward hole (F) it may be necessary to lower exhaust and heat shield.
(more…)
Categories
Archives
Cars PDF Document is proudly powered by WordPress - BloggingPro theme by: Design Disease