Prepare for the installation.
• If possible, install the SWI-X while you are installing the new head unit. Keep in mind you may need to plug in the factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-X is working properly.
• Plan a general installation location for both the SWI-X LED and the control body. Keep in mind that the supplied wire harness is two feet long, and the IR harness is four feet long.
• Use a multimeter or approved measuring device for checking vehicle circuits.

Step 1.
Connect the BLACK wire to ground (-).
Verification: Wire or location registers a constant (-) when probed.
Step 2.
Connect the RED wire to switched +12V.
Verification: Wire registers +12V when the ignition key is turned to the ACC or ON positions.
Step 3.
Connect the appropriate interface wire (WHITE, YELLOW, ORANGE or GREEN).
• Refer to the Appendix E – Identification and Connection Chart (pages 6-7). Locate the vehicle and note the SWC wire color in the “Interface Wire Color” column.
• Note the vehicle wire color and location information in the “Identification” column.
Note: You will only connect ONE of these wires. Cut and insulate the unused wires.
• Connect the wire as indicated.

Download

Related Tags: appendix, circuits, color column, connect one, control interface, factory stereo, four feet, installation location, interface instructions, location registers, measuring device, multimeter, steering wheel, step 1, step 2, step 3, swc, two feet, wire harness, yellow orange