For details consult an authorized NISSAN dealer 4 32 Heater air conditioner and audio systems 5 Starting and driving Precautions when starting and driving 5 2 Exhaust gas carbon monoxide 5 2 Three way catalyst.

Do not leave children unreliable adults or pets alone in your vehicle. They could accidentally injure themselves or others through inadvertent operation of the vehicle Also on hot sunny days temperatures in a closed vehicle could quickly become high enough to cause severe or possibly fatal injuries to people or animals Properly secure all cargo to help prevent it from sliding or shifting Do not place cargo higher than the seatbacks In a sudden stop or collision unsecured cargo could cause personal injury If you suspect that exhaust fumes are entering the (more…)

• 0 Comments

When any of the memory switches are pushed while the automatic drive positioner is operating When the adjusting switch for the driver s seat is turned on while the automatic drive positioner is operating When the memory switch 1 or 2 is not pushed and held for at least 1 second When the seat has been already moved to the memorized position When no seat position is stored in the memory switch When the automatic transmission selector lever is moved from P Park to any other position When the driver s door remains open more than 45 seconds and the ignition switch is not in the ON position The automatic drive positioner system can be adjusted and canceled For vehicles with navigation system see Vehicle electronic systems in the Display screen heater air conditioner and audio systems section of this manual For vehicles without navigation system see your NISSAN dealer Pre driving checks and adjustments
(more…)

• 0 Comments

Remove Factory Radio
STEP 1: Locate and remove two (2) phillips screws that secure the top of the plastic panel that covers the radio and air conditioner controls. They should be located next to the air conditioner vent levers directly above the (2) air conditioner vents. Pull the plastic panel gently from the top to remove it from the dash.
STEP 2: The radio will be held in with two (2) 7mm bolt screws; one on each side of the radio. Remove both.
STEP 3: To remove the radio, pull firmly. Unplug all connectors (1 blue, 1 white, 1 black) from the rear of the radio. Unplug the antenna cable from the rear of the radio. The radio is now free to be removed from the dash panel.
STEP 4: Since the opening is so big in the dash, The Install Doctor recommends using the plastic mounting bracket attached to the bottom of the radio just removed.
This bracket can then be attached to the bottom of the plastic radio installation kit and assure that this kit is properly aligned and secured to the dash.
(more…)

• 0 Comments