TO START:
1. Turn off the ignition and disconnect the negative battery cable.
2. Disconnect the mass air sensor electrical connection and unhook the mass air sensor wiring from the engine cover.
3. Remove the two screws shown that secure the fresh air tube to the fresh air duct.
4. Pull up firmly on the air filter housing/engine cover assembly to release it from the mounting grommets.
NOTE: The air filter housing/engine cover assembly is still attached to the intake inlet tube.
5. Using pliers, release the spring clamp that secures the intake to the intake inlet. Then unhook the intake tube from the inlet.
(more…)

• 0 Comments

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen the hose clamp on the intake tube at the throttle body.
4. Loosen and remove the bolt that secures the air cleaner assembly to the inner fender.
5. Detach the crank case vent hose from the intake tube.
(more…)

• 0 Comments

Installation Step:
1. Disconnect the negative battery cable! Push the green tab on the crankcase breather tube, and disconnect it from the air intake tube. Loosen one hose clamp on each end of the air intake tube and remove it from the vehicle.
2. Remove the four bolts that hold the throttlebody to the intake manifold.
3. Install the ECONOAID Plate against the manifold with the logo facing the throttlebody. Next install the supplied gasket between the ECONOAID Plate and the throttlebody.
(more…)

• 0 Comments