The installation of the AEM ECU on the 2000-2003 Mitsubishi Eclipse/Lancer uses the stock sensors and actuators. The base map is automatically installed in the base calibrations directory in the AEMPro directory on your computer. It is named either 1312 Lancer.v1.00.cal or 1312 Eclipse.v1.00.cal.
Full details of the test vehicle used to generate this map can be found in the files notes section. However, while the base map is a good starting point and may save you considerable time and money, it will not replace the need to tune your specific application. It is not intended to be driven aggressively. Ignoring this can and will damage your engine.
(more…)

• 0 Comments

The installation of the AEM ECU on the 1995-1999 Mitsubishi Eclipse Turbo / Eagle Talon Tsi uses the stock sensors and actuators. The base map is automatically installed in the base calibrations directory in the AEMPro directory on your computer.
Full details of the test vehicle used to generate this map can be found in the files notes section. However, while the base map is a good starting point and may save you considerable time and money, it will not replace the need to tune your specific application. It is not intended to be driven aggressively. Ignoring this can and will damage your engine.
(more…)

• 0 Comments

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
(more…)

• 0 Comments

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temp. sensor electrical connection.
3. Loosen the hose clamps at the turbo inlet and the airbox outlet as shown.
4. Remove the intake tube from the vehicle as shown.
5. Loosen and remove the 10mm nut that retains the airbox to the vehicle.
6. Remove the complete airbox assembly from the vehicle as shown.
7. Remove the airbox mounting grommet as shown.
8. Install the large “L” bracket onto the heat shield with the provided hardware. NOTE: Do not tighten completely.
(more…)

• 0 Comments