Installation Pro.Fit Kit on Ford Transit Connect. Place the DTRT and the Hook Tool in the space between the dash molding and the air vent bezel above and to the right of the radio. Use the hook tool first to gently pry up the air vent bezel sufficient enough to insert the DTRT. Use the DTRT in a gentle twisting motion around the bezel to release the eleven (11) retainer clips securing the air vent bezel to the dash molding. Place bezel off to the side. Insert four (4) Mercedes/Audi radio removal tools in the slots located in the four corners of the radio as indicated by the arrows in Picture 1. Follow radio removal instructions included with the radio removal tools part number (DM-20-22).
(more…)

• 0 Comments

READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.
TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), 10mm socket and driver, #2 Phillips screwdriver.
PARTS INCLUDED: One phone mount , Three (3) #8×3/4” self tapping screws
LOCATION OF MOUNT: To the right of the radio
(more…)

• 0 Comments

STEP 1. Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece. Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do not disconnect the wiring . STEP 2. Under the temperature control module is a small black panel that is held in (more…)

• 0 Comments

Step 1: Remove Trim Panel
-Start at the bottom edge of panel and gently pry out near storage pocket area. Move up to near the stereo and pry out again. The last two clips are at the top above the air vents, pry these out and the entire assembly will release.
-The climate controls are attached to the trim panel so next step is to remove the wiring clips from the rear of the unit. Now remove the wiring clips from the upper button assembly.
(more…)

• 0 Comments