The mounting procedure outlined below covers CHEVROLET (1988 – 2000), and 1 ton trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Position the PUSH BEAM SUPPORT PLATES (Ref. 62A and 62B, Fig. 1) to the front frame rails of the truck. If the truck is equipped with tow hooks, remove the tow hook bolts, and tow hook before installing the PUSH BEAM SUPORT PALTES. Using M14 x 2.00 Hex Head Bolts and M14 Lock Washers provided, bolt the PUSH BEAM SUPPORT PLATES through the outside of the frame. Next use ―” – 13 x 1- ―” Hex Head Bolts, ―” Flat Washers, and ―” – 13 Hex Head Self Locking Nuts to bolt the PUSH BEAM SUPPORT PLATES through the bottom of the frame. Tow hooks may be relocated under the PUSH BEAM SUPPORT PLATES and reattached. Fasteners should only be finger tight.
(more…)

• 0 Comments

The mounting procedure outlined below covers the 2000 – 2004 Dodge Dakota trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Disconnect fog lamps from bumper if equipped on vehicle.
2. Cut rubber portion of air deflector attached to bumper and discard. Open vehicle hood and remove four vertical bumper bolts from existing Bumper Brackets (BB). Remove bolts from two outer bumper brackets if equipped on vehicle. Remove bumper.
3. Clamp existing Bumper Bracket (BB) to frame rail. Remove two existing Nuts (AA) from Bumper Bracket (BB). Use chisel and hammer between head of existing Bolts (CC) and Bumper Bracket (BB) to force them loose. Use caution to prevent damage to parts. Unclamp and remove Bumper Bracket (BB). Repeat process on opposite side of vehicle.
(more…)

• 0 Comments