This Blow-off valve kit is specifically designed to fit a standard engine. If your engine has non-standard intercooler piping this kit may require modification. IMPORTANT NOTES ON KOMPACT DUAL PORT BOV FITMENT TO AUDI V6 BI-TURBO AWD Turbosmart recommends that your Blow-Off Valve (BOV) is fitted by an appropriately qualified technician.
(more…)

• 0 Comments

The K&N intake tube installation:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the mass air sensor electrical connection.
3. Loosen hose clamp at the mass air, then remove the three 10mm bolts that secure air box to vehicle.
4. Remove air box from vehicle as shown.
(more…)

• 0 Comments

The instructions step:
• Place the bike on the center stand and remove the current shock absorber.
• Place the Hyperpro shock in the bike, type 461 with reservoir as shown in the picture. If your shock is equipped with the optional hydraulic preload adjuster place the banjo bolt of the HPA to the right side of the bike.
• Use the two added clamps and rubber blocks to mount the reservoir on the sub frame
(more…)

• 0 Comments

General Guide – Setting & Locking FIAT TWIN CAM engines. Timing belt replacement on 1.6, 1.8 16v. and 2.0 20v. Fiat twin camshaft engines is carried out with the crankshaft at TDC, established by using VS1404 TDC Position Tool and a DTI (Fig.1), to determine the piston position in No.1 cylinder, and then by checking that all timing marks align. NOTE: To avoid kit contents duplication, VS1404 TDC Position Tool is not included in individual kits but is available as an Associated Tool. It is used on Fiat 1.6, 1.8 and 2.0 multi-valve engines.
(more…)

• 0 Comments

Thanks again for purchasing your new 409 stainless steel Pypes Performance Exhaust Ford Mustang off-road or street legal x-pipe. Please be sure to confirm all the components in the kit were received in your shipment before beginning installation. All kits will include your new x-pipe with 02 bungs, installation hardware, and header sleeves (if required). If you purchased a street legal version, you should have also received a CVM10K or CVM11K cat kit. If you purchased XFM16, you received (1) small sleeve for the drivers side leg. If you purchased XFM19, both mounting points at the headers require the (2) small sleeves supplied. If you find any component missing, please contact our office at 800-421-3890 for replacement.
(more…)

• 0 Comments

INSTALLATION
Note: This kit is designed to be used on 74-78 Mustang II and 73-80 Pinto/Bobcat spindles. It will also fit most dropped spindles and tubular “A” arm combinations. Check the fit before painting or plating any parts.
Painted, plated or modified pants are not accepted for return.
1. Starting with a clean spindle, mount the appropriate bracket {there is a right and left hand bracket) to the spindle using the bolts supplied. Note: brackets stamped R are right-passenger side and L are left-drivers side.
(more…)

• 0 Comments