Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
(more…)

• 0 Comments

For rear disc pad removal and installation, DO NOT disconnect brake hose from caliper (wire aside). Replace all pads on an axle if wear indicator on any pad contacts rotor or if pad is worn to within .03″ (.8 mm) of pad backing.
Removal (”A”, “B”, “C”, “K” & “U” Series)
1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Remove wheel. Using “C” clamp, compress caliper piston until it bottoms out in its bore.
(more…)

• 0 Comments