Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle General Information.
2. Disconnect the electrical connector and air line if equipped with Real Time Damping (RTD) .
3. Support the rear axle.
4. Disconnect the RTD sensor ( if equipped). Refer to Rear Position Sensor Replacement -
Electronic Suspension – Left (15 Series) or Rear Position Sensor Replacement -
(more…)

• 0 Comments

The following instructions begin after the timing cover and old timing set have been removed.
Installing the timing set and degreeing the camshaft will be easier if you loosen the rocker arms so that the camshaft can turn freely. You should be able to turn the camshaft by hand. Make sure that the engine mounting surfaces and your new timing set have been thoroughly cleaned with a good solvent. If you are using a timing set with three keyways, select the appropriate keyway for your camshaft timing specifications. COMP Cams ® recommends the standard timing position for most applications. This position uses the round or “O” timing and keyway marks. Standard Timing Location: This is the same as original O.E.M. setting. Use keyway and crankshaft gear tooth marked “O”.
(more…)

• 0 Comments

Installation Instructions. Read Me! Rv. 01/04
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (3) nuts & studs from the throttle body & manifold. (Ref. “C”)
4. Remove support bracket from engine block to throttle body. (Ref. “D”)
* Please Note: When removing support bracket bolt at engine block, loosen bolt enough to remove bracket. DO NOT REMOVE BOLT.
(more…)

• 0 Comments