The installation instructions step:
1. Disconnect the negative battery cable! Loosen two hose clamps and remove the air intake tube. Separate the intake tube from the plastic clamp on the upper radiator hose. (If equipped).
2. Using a 10mm socket, remove the three nuts that hold the throttle body to the intake manifold.
3. Using a 4mm socket, remove the three studs that go thru the throttle body into the intake manifold.
(more…)

• 0 Comments

Installation of Full Tilt Street Rods’ Crossmember Kit is easy because we have designed all the correct angles onto our crossmember. You must make a couple of measurements to correctly place the crossmember and spring mounts before welding. Minor adjustments may be needed for some variations in your frame. We recommend that all welding be done by a qualified welder using accepted procedures. We also recommend that a professional alignment shop do all wheel alignment.
(more…)

• 0 Comments