This manual is divided into different areas to assist you with your installation and operation of your steering box support system. This product is not a replacement for a new steering box and/or ball joints, but it will aid in reducing the stress placed on the steering box and associated wear. All steering components should be checked and replaced if necessary prior to addition of the steering box support. Installation should occur on a vehicle properly secured to prevent rolling. Application of lubrication at regular chassis lube intervals will promote bearing life.
(more…)

• 0 Comments

Subject: Starter motor Failure
Model: Ford 2.0 TDCI FWD & 2.4 TDCi RWD/2.0 TDCi FWD
On inspection, the units do not exhibit any manufacturing defects. The premature failure of the unit is due to contamination of the pinion/drive area from metal dust particles produced within the Dual-mass Flywheel, when the clutch wears or becomes overheated. During scheduled servicing, it is recommended that the clutch is checked and if found to be showing signs of wear should be replaced.
(more…)

• 2 Comments

For rear disc pad removal and installation, DO NOT disconnect brake hose from caliper (wire aside). Replace all pads on an axle if wear indicator on any pad contacts rotor or if pad is worn to within .03″ (.8 mm) of pad backing.
Removal (”A”, “B”, “C”, “K” & “U” Series)
1. Remove 2/3 of brake fluid from master cylinder reservoir. Raise and support vehicle. Remove wheel. Using “C” clamp, compress caliper piston until it bottoms out in its bore.
(more…)

• 0 Comments