This coil spring lift kit should only be installed on vehicles in good working condition. Before installation, the vehicle should be thoroughly inspected for evidence of corrosion or deformation. This coil lift kit should not be installed on any vehicle that is suspected to have been in a collision or misused. Failure to observe this warning may result in serious personal injury and/or severe damage to your vehicle.
(more…)

• 0 Comments

Rosen Multi-Media systems are the easiest-to-install OEM Radio replacement systems available today. However, we strongly recommend reading this guide before starting the installation! Make sure you have the tools you will need. These common items are needed to complete this installation:
· Digital multi-meter (DMM)
· #2 Phillips screwdriver
· Panel removing tools
· 1/4” drive sockets are often needed for dashboard and trim disassembly
· Torx or Allen-drive wrenches if they are used on any panels you will be removing
· A DVD or CD in good condition for testing the system
(more…)

• 0 Comments

This kit was designed for use with TM Kit# F4531. Use of this kit with other suspension kits and shocks, including coilovers, has not been verified. Proceed with caution. Interferences may exist. This kit should only be installed on a vehicle that is in good working condition. Before you install the kit, thoroughly inspect the vehicle for corrosion or deformation of the sheet metal. If the vehicle is suspected to have been in a collision or misused, do not install this kit. Off-road use of your vehicle with this kit installed may increase the stress applied to the factory components. Failure to observe this warning may result in serious personal injury and/or severe damage to your vehicle.
(more…)

• 0 Comments

Proper installation of this kit requires knowledge of the factory recommended procedures for removal and installation of original equipment components. We recommend that the factory shop manual and any special tools needed to service your vehicle be on hand during the installation. Installation of this kit without proper knowledge of the factory recommended procedures may affect the performance of these components and the safety of the vehicle. We strongly recommend that a certified mechanic familiar with the installation of similar components install this kit
(more…)

• 0 Comments

1. Module Installation: You will need to run the wiring harness thru the firewall and attach your power module to the harness inside the cab of your truck. Place the module under the dash out of the way
of your pedals.
2. Data Link Connection: The Data Link connector is located in different locations based on the year of the truck.
98.5-99: The triangle shaped connector is located on the driver’s side of the engine in the wiring harness near the power steering pump.
2000-2002: The three prong flat connector is located on the top of the fuel lift pump that is located on the driver’s side of the engine directly below the map sensor.
Note: on some 2001 trucks the connector is located on the driver’s side of the engine in the wiring harness near the power steering pump.
(more…)

• 0 Comments

Installation of a Performance Automotive group body lift will change the center of gravity and the handling characteristics of the vehicle. Because of the higher center of gravity and larger tires, the vehicle will handle and react differently both on and off road. You must drive it safely! Extreme care must be taken to prevent vehicle rollover or loss of control, which could result in serious injury or death. Avoid sudden sharp turns or abrupt maneuvers and always make sure all vehicle occupants have their seat belts fastened.
(more…)

• 0 Comments