Vehicle Application: 2003 Audi A4 1.8L, Vin C, Turbo, Eng Cfg L4, Eng Des AMB
Customer Concern: Unstable Idle, Multiple codes P1136 Bank 1 Mixture adaptation Additive Range System To Lean P1297 Connection Charger to Throttle Valve Loss Of Pressure P0300, P0301, P0302, P0303, P0304 Misfire codes P1479 Brake Booster Vacuum Supply Malfunction
(more…)

• 0 Comments

Moroso Crankshaft Wipers are designed so that they can be trimmed to fit the widest possible range of counter-weight, rod/stroke configurations. They are to be mounted to the starter side of the block only. The Moroso Crankshaft Wiper is engineered to clear assemblies down to 2.9 IN. of stroke using stock type rods. As the stroke is increased and /or larger rods used, the amount of material to be removed increases. Do not be alarmed at the amount of grinding and trimming with shears which may be necessary to clear your particular assembly. We recommend.030” to .045” clearance around all moving components. After you have trimmed your wiper, be sure to smooth all edges to prevent all potential engine damage due to burrs vibrating off into the crankcase. Before final assembly, double check for clearance when the crankshaft is rotated a full 360 degrees. Be sure to account for “thrust end play” while checking for proper clearance. After final fitting and deburring, cement the wiper to the block. You can use contact cement or weather-strip adhesive (An alternate method would be to use tiny flat head screws or pinning). Next, install the pan gaskets in the usual manner. Due to the slightly increased height on one side,
Be sure to use a dab of silicone in the corners where the rubber ends meet the side rail gaskets.
(more…)

• 0 Comments

Read and understand these instructions BEFORE attempting to install this product
1) Getting Started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) If engine has run with in the past two hours let it cool down.
d) Disconnect negative battery terminal. ~:
e) Raise front of truck and support with properly rated jack stands.
f) Remove passenger side, front tire.
(more…)

• 0 Comments

Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
(more…)

• 0 Comments

Installation Step:
1. Disconnect the negative battery cable! Push the green tab on the crankcase breather tube, and disconnect it from the air intake tube. Loosen one hose clamp on each end of the air intake tube and remove it from the vehicle.
2. Remove the four bolts that hold the throttlebody to the intake manifold.
3. Install the ECONOAID Plate against the manifold with the logo facing the throttlebody. Next install the supplied gasket between the ECONOAID Plate and the throttlebody.
(more…)

• 0 Comments